| WAND READERS |
|
|
![]() [ 1 - 2 ] |
CL30 Steel Wand
The CL30 is a rugged pen type bar code reader. Its stainless steel case and synthetic ruby ball tip give extra protection against any
damage. This ruby ball tip allows a consistent read performance by protecting the optics from dust and dirt. With a smooth stroke it reads the labels
easily and does not damage the paper. |
The presence of optical bandpass filters and electrical filters ensures that the CL30 will read bar code labels in direct sunlight or
under strong fluorescent lighting. The CL30 is standard available with either a red or infra-red light source.
A range of resolutions from 0,10 to 0,40 millimeters is available to accommodate reading both high, low and medium density
labels. Because of its durability and tilt angle of up to fifty degrees, this bar code wand is a perfect scanning device to be used in combination with
hand held terminals. The high speed circuitry provides for output of a good quality TTL-Signal.
| CL30R-N10x |
Wand red light source. |
| CL30I-N10x |
Wand Infrared source. |
| PT11-30 |
Plastic holder. |
| Electrical : |
Voltage: from 4,3 to 5,5 Volt dc. Consumption: massimo 35 mA. |
| Functionality : |
Light Source: 660 nm LED ( red ) 940 nm LED ( infra red ). Interface: TTL compatible or Open Collector. Scan Speed: from 34 to 3700 mm/sec. for resolution 0,15mm. Tilt Angle: from 0° to 50° C. Ambient Light rejection: fluorescent 2.000 lux max. direct sun 70.000 lux max. |
| Environmental : |
Temperature: Operating Temperature from -10° to +50° C. Storage temperature from -20° to +70° C. Humidity: 95% non condensing. |
| Physical : |
Dimensions: 12,8 diameter x 173 ( L ) mm. Weight: 120 gr. |
|
[ previous ]
|